Five ways to automatically detect the hard disk when Win7 is disabled.

Many users who use Win7 system should have encountered such a situation: each time they start up, they will automatically detect the hard disk error, which will take a long time to boot. So how do we avoid this happening?

The method is as follows:

Method 1, or you choose to check the hard disk every time you boot in the BIOS settings, and your Computer configuration is irrelevant. Solution After booting, press DEL to enter the BIOS and select Quick Power On Self Test. You must be set to Enabled. Select Disabled and turn it off.

Method 2: If the partition is in FAT32 format, it is recommended to convert it to NTFS by opening a command prompt and typing: convert X: /fs:ntfs, press Enter.

Method 3: Modify the registry, open the registry and navigate to [HKEY_LOCAL_MACHINE/SYSTEM/CurrentControlSet /Control/Session Manager], and find “BootExecute:REG_MULTI_SZ”” in the window on the right. The key value is Windows on the disk scan, double-click "BootExecute: REG_MULTI_SZ"; change its content to: "autocheck autochk *", press Enter to restore the normal state, or delete all the numerical data inside, so that you can thoroughly It is forbidden to run ScanDisk when it is illegally shut down and restarted.

Method four, if it is due to the non-normal shutdown, if every skipped each time still to run, if not the cause, then we should check the D disk status is normal, correction The error of the hard disk is as follows: Click “Start”→“Run”, enter "ldk;skkdskX:/f” (x is the drive letter) in the window, this command can check the file system Logic error, and repair, and then start & ldquo; defragmentation rd defragment the corresponding disk, can eliminate the disk scan again, or not, then there may be bad sectors on the hard disk, the easiest way is to Back up the data of the D drive, and then format the D drive so that it can be used normally.

Method 5, open & ldquo; computer & rdquo; then right click on the X drive to select & ldquo; attribute & rdquo; - select & ldquo; tools & rdquo; - & ldquo; check & rdquo; midpoint & ldquo; start check & rdquo; - selected “Automatically fix file system errors” and “Scan and try to recover bad sectors”, then click “Start” to perform scan repair.

The above are the five methods that Xiaobian sorts out. If friends encounter a boot and automatically detect the hard disk, they may choose a method to try. The effect is definitely immediate.