The consequences of installing win7 with the wrong hard disk partitioning tool

A hard disk partition is essentially a format for a hard disk before you can use the hard disk to save various information. Before installing the operating system and software, you first need to partition and format the hard disk before you can use the hard disk to save various information. However, you should also pay attention to the use of hard disk partitions. A little carelessness may lead to very serious consequences. Today, I will explain to you that installing Windows7 and using the hard disk partitioning tool inadvertently lead to a series of results, which also makes the author's mood very depressed. Isn't it bad?

I decided to install Windows 7 today because I used to use only one system and never thought about dual systems. As a result, I played big today and I was depressed. Tell me about my depressed things.

I have two hard drives, one 160G (three zones, C, D, E), one 1T (one zone, F 930+G, partition mode is extension.) because I only use one system Yes, so when installing Windows 7, delete the C drive and rebuild it; after the result is rebuilt, it has a 100MB disk. I don't know what to use, I don't feel too comfortable. There is an extra 100MB disk. Just exit the installation.

PQ prompts the disk error, forget it, no matter it, cancel, find that even the second hard disk is also a disk error? What does Windows 7 do? I have not touched the second when I installed Windows 7. A hard drive, because I have always had a lot of important information on the 1T hard drive.

The problem of depression is coming. Boarded PQ and found that both hard drives were all yellow. Ok no matter what. Exit PQ.

I found Windows PE (XP) and found that the disk is still there. I thought it was over, I didn't install Windows 7, I got on PQ, I got an error, and I fixed it.

Depressed, point to this fix, the problem is big (after the event), after the repair, enter the PQ, the two hard drives are still yellow.

Ok, don't dare to touch, board Ghost and restore XP, this is good, all the disks in the first district are gone. However, the logical area (1T) of the second hard disk can be detected.

That can't be recovered?

Then put it into the XP CD, look at the new installation, install the partition step in XP, find all the disks are in, delete the two built Windows 7 plate. Rebuild back to the system area.

Then I can finally restore Windows XP with Ghost.

But the strange thing is that Ghost still can't detect D, E area, but after entering XP, all partitions still exist.

The data is currently being backed up, data in the D, E area. Depressed, this is really big. . There is also F disk is 930G, I have used 900G, this 900G do not know how to back up.

Lessons learned, when you install Windows 7, if the original hard disk has data, don't use Windows 7 partition to build the disk. After using Windows 7 to build the disk, PQ will prompt an error. NND, the second unconnected disk connected is also wrong. Although the data is still there, it feels very dangerous and I don't know how to do it.