How to set up the bearer network under Win8 system?

The first step is to check if the computer supports network sharing.
At the command prompt (open the way to see the article at the end), type: netsh wlan show drivers, then press Enter.
Find "Supported bearer network" one, if the following is displayed as "is", congratulations, your computer supports the bearer network to share, otherwise, think about it again!
The second step is to set the username and password of the shared network.
At the command prompt, type: netsh wlan set hostednetwork mode=allow ssid=WifiName key=WifiPasswd Enter
ssid is set to Wifi name, key is password Item
After the carriage return, it will display
Step 3, start the bearer network
Enter in the command prompt; netsh wlan start hostednetwork
Enter
Step 4, close the bearer network< Br> At the command prompt, type: netsh wlan stop hostednetwork
Enter
Step 5, Possible problems
In the third step, it may fail to start. The solution is as follows:
Right-click on My Computer - Management - Device Manager - Network Adapter, check if there is a yellow logo in front of the Microsoft kernel debug network adapter, if any, that you have not started, right click - start, then try again Step 3 will start successfully. If it still doesn't work, you can try to update the NIC driver (not tried)
Step 6, win 8 command prompt startup mode
Micro software+R: Enter cmd, Enter
at the bottom left of the desktop Corner, right click, in the shortcut menu that appears, select "Command Prompt"/"Command Prompt (Admin)"