Win7 system computer when the U disk formatted prompt Windows can not complete the format of the two solutions

, such as a user recently said that the Ghost win7 system computer U disk formatting operation prompts "windows can not complete the format", How to solve this problem? The following Xiaobian and everyone share the specific solution, the user who encountered this problem to see the following steps.


































The 360U disk identification & rdquo; tool to detect the actual capacity of the U disk, in order to select the appropriate "file system" type in the formatting operation. When the U disk memory is larger than 1G and less than 4G, it is recommended to use the Fat32 format for formatting operations;

Software name:

360u disk evaluator (u disk check tool) v1.0.0 .1029 free Soft

software size:

1.68MB

updated:

2016-01-06



2. When performing a format operation on the USB flash drive, in the pop-up "Formatted removable disk" window, click the "Restore default value of the device" button, and then click "Start” The button attempts to format the USB flash drive;

3, select “low-level format & rdquo; U disk. In the "Formatted Removable Disk" window that opens, uncheck the "Quick Format" item, and then click the "Start" button to try to format the USB drive;

4, right Click on “Removable Disk” and select “Attributes” from the pop-up menu. And in the window that opens, switch to the "Tools" tab, click “Check the error to start detection  ;

5, in the pop-up window, make sure the first item is selected, then click &ldquo Start repairing & rdquo;;


Solution 2:
1, open “Run” dialog box (press Win+R key combination to open), enter “CMD” enter MSDOS Interface;

2, then enter “format j: /fs:fat32” (where j represents the drive letter of the U disk) and press Enter to perform the U disk format operation;

3. When the prompt shown in the figure pops up, it indicates that there is a bad panel on the disk, and the disk may be damaged.

4. When the above error occurs, due to the bad sectors of the large panel, The U disk has a reduced available capacity, so you can only use the “Fat” file system to format the U disk;

5. If the U disk has fewer bad sectors and the available capacity is greater than 512M, it can be used. Produce tools to repair U disk.
Related reading:
Win7 system computer read U disk prompts Windows write cache failure solution
After installing Win7 system, only the U disk can be booted from the hard disk to enter the system failure reason and solution < Br> The above is the introduction of the two solutions to the win7 system computer when the U disk format prompts windows can not complete the format of the solution, the method is very simple, the same problem, you can follow the above methods to set up to solve.