Three solutions to the "Windows installer can't configure windows..." when installing Win8.1 system

During the installation of win8.1 system, the prompt "Windows installer can not configure windows to run on the hardware of this computer", the specific problem phenomenon is as follows:

Solution 1: Change the hard disk mode to AHCI compatibility mode.
1. Boot into bios (depending on the model of your computer). 2.-->config. 3.-->Serial ATA (SATA). 4.--> Set the SATA Controller Mode Option to AHCI.
Workaround 2:
When the above prompt appears, press shift+f10 to open the command window, enter the C:\\windows\\system32\\oobe folder, type msoobe and press Enter to proceed to the next step. Enter the username and password for the operation.
Workaround 3:
If none of the above can solve your problem, please note that your current partition is not the system disk (usually C drive) capacity is allocated the smallest of several partitions, If so, repartition and enlarge the capacity of the C drive so that it is not the smallest of all partitions.
Related reading:
Win8.1 system switching using Administrator prompts "Unable to use the built-in administrator account to open the program" solution Win8.1 system connection WLAN prompts "Unavailable" failure analysis and resolution Method
The above is the installation of Win8.1 system prompts "Windows installer can not configure windows to run on the hardware of this computer", all the contents of the three solutions, more content, please continue to pay attention to this!