The installation of win7 system prompts "can not update the startup configuration" failure reason analysis and solution

Installing win7 system prompts that Windows cannot update the startup configuration of the computer, and the installation cannot continue. As a result, the win7 system installation cannot be successful. The specific problem phenomenon is shown in the following figure:

Fault reason analysis:

This problem may be caused by the master boot record, so the repair method is also based on repairing the master boot record.

Solution:

1. Delete the previous 200M disk, and go to the c drive. Format the c drive. Repair the partition table. Rebuild the master boot record (MBR);

2, then the ghost system to the c drive;

3, or because your boot disk is not unplugged, the computer jumps from the boot disk to Hard disk boot, solution: After copying the file, remove the boot disk or set it as hard disk boot before restarting the installation.

The above is the reason for the installation of win7 system "can not update the startup configuration" and the solution to all the contents of the introduction, after the installation, successfully installed win7 system!