When Win8.1 starts the Security Center service, an error message pops up. 1068

In the Win8.1 system, starting the Security Center service will provide the user with the most comprehensive system security status, and promptly prompt the user for all security information, but there are users. When the Security Center service is started, the error message 1068 that the service cannot be started is popped up: The dependent service or group is not started. The following small series teaches you how to solve this problem.

Method 1:

1. Use the key combination Win+R to call up the run command box, type the commands services.msc, and press Enter.

2. If the user account control window pops up, please allow to continue. Locate the Security Center service and double-click it to open the service properties. In the General tab, select the startup type as Auto, and then click the Start button in the service state;

3. If the win8.1 system service startup still fails, please refer to the above steps to enable the Remote Procedure. Call (RPC) and Windows Management Instrumentation are two services.

4. After the above two services are successfully started, please try to start the Security Center service again to check whether the startup is successful.

Method 2:

1. Turn on the service in safe mode and press F8 to enter safe mode. After entering the security mode, please press the method 1 to start the Security Center service, check whether it is successful;

2, in the security mode can successfully start the Security Center service, we can then use the clean boot method to check A program service that causes conflicts.

The above is a small way for everyone to solve the problem of not being able to start the security center service and there is a 1068 error, thus ensuring system security.