How to solve the Dell notebook installation WinXP disk confusion problem

Many old Dell notebooks when installing WinXP, as long as there is no use of Dell genuine WinXP CD, there will be various problems, I believe many friends using Dell notebooks Have encountered. Some time ago, Xiaobian appeared in the following questions when helping a friend install WinXP:

The friend computer is Dell Vostro 1200. During the process of installing WinXP, the system prompts that the hard disk cannot be found, and the Linux rescue disk is used. After entering, all partitions were deleted with fdisk, and Windows XP was installed again, and the fault remained. Later, I learned that because the SATA interface of the hard disk is different, the corresponding WinXP installation disk with integrated SATA driver must be used for normal installation.

After installing WinXP small series continue with the installation of after-hours integrated SATA, successfully resolved the problem, of course, the above is a simple question, many users are aware. However, after installing the WinXP system, it was found that the two hard disk partitions became E: and F:, the system was installed on E: and C: but the card reader occupied the position. Later, I tried to change the system to the C: disk by modifying the registry, but it failed.

Dell laptop installation WinXP has a messy mess! This issue is the focus of what we said today, many users do not know how to solve this problem, in fact, this is a small problem set by Dell notebook. The solution is also simple, that is, enter the BIOS to turn off all onboard USB devices, and then install it without problems.

Entering the BIOS to turn off all USB devices and installing the WinXP system again, this time it is finally a problem. Finally, Xiaobian summarizes the two points that Dell XP should pay attention to when installing WinXP. First, it is necessary to use WinXP installation version that conforms to the original model interface. It is best to use genuine CD. Second, you must enter the BIOS to turn off the USB device beforehand. Staying on these two points, you will have no problem installing the system.