Windows security mode solves difficult problems

When using Windows XP, there may be a blue screen, the font becomes large and fuzzy, restart, and crash, because the installation driver is not correct, which often causes various problems in the Windows XP system. At this time, we need Uninstall these drivers that make Windows XP go wrong. However, some drivers need to be uninstalled in Windows XP security mode. Below, teach you how to use Windows XP security mode for our better service.

First, try to detect incompatible hardware in safe mode

XP uses a digital signature driver mode, and the detection of various hardware is stricter than before, so some devices It may not be driven under normal conditions. If you find that XP does not recognize the hardware in normal mode, you can press F8 at startup and then enter safe mode. When you detect new hardware in safe mode, it is possible to load the driver correctly.

Driver can not be uninstalled? Quickly clean in safe mode

Second, uninstall the incorrect driver

General driver, if your hardware is not applicable, Can be uninstalled by XP driver restore. But the graphics card and hard drive IDE driver, if installed wrong, it is possible to enter the GUI interface to crash; some motherboards ULTRADMA patch is also the same, because Windows is to read the memory and disk page files to adjust the computer state at any time, so the hard drive one The system will crash if there is a problem. What should I do now?

We can enter XP's safe mode. In safe mode, Windows uses the default settings (VGA monitor, Microsoft mouse driver, no network connection, minimum device driver required to start Windows), and safe mode. Start with the least amount of service, so the wrong IDE and graphics driver will not load, you can delete the software or hardware that caused the problem, and use the driver restore to restore the system. In Windows9X, it is not so convenient, so although XP has a higher hardware requirement, it is worth using.

Third, the problem of interrupting the connection state is fixed in safe mode

In some cases, disabling the administrator account may cause maintenance difficulties. For example, in a domain environment, when the secure channel used to establish a connection fails for some reason, if there is no other local administrator account, the computer must be restarted in secure mode to fix the problem that caused the connection state to be interrupted.

If you attempt to re-enable a disabled administrator account and the current administrator password does not meet the password requirements, you will not be able to re-enable it. In this case, the optional member of the administrator group must set the password for the administrator account through the “local user and group" user interface

four. You can also use the last correct configuration to modify it back to the previous normal system.

Security mode is a convenient debugging tool that Microsoft brings to us. It is definitely not a chicken rib. I hope everyone can be familiar with and use the safe mode. It also allows everyone to take fewer detours.