Android phone only charging can not connect to the computer how to do

Sometimes the Android phone is not recognized by the system after it is connected to the computer. The mobile terminal only has a connection mode. At this point, how can I get the computer to find the phone and exchange data? With the popularity of the Android 4.x system, many mobile phones have canceled the "large-capacity storage" mode, and can only transfer data in the form of MTP (media synchronization) after connecting with the PC. The problem is that sometimes when the phone is connected to a PC, even the MTP mode is gone, leaving only <; charging only & rdquo; one (Figure 1). In case of such problems, it is recommended to install the client software such as pea pod on the PC, and then find and open the “USB debugging mode” in the system settings of the mobile phone. After connecting with the data cable of the PC, the pea pod will automatically Download and install the phone driver, and the phone will be recognized by the PC later. If the phone is still only "charged" after downloading the driver, please go to the device manager and check if the ADB driver of the corresponding phone has a yellow exclamation mark. If there is, it means that the driver installation was unsuccessful or mismatched (Figure 2). You can now remove the device in Device Manager and run the pea pod again to reinstall the driver. Tip: If the client software such as pea pods cannot download the mobile phone driver correctly, you can log in to the mobile phone brand website to download the PC driver, and then manually specify the ADB device and update it in the device management. This article comes from [System Home] www.xp85.com