The WiFi sharing master opens the solution that the network card is not turned on

  
WiFi sharing master is a very convenient network sharing software, but some users will detect that the wireless network card is not turned on when creating the WiFi network. The following system is a small series for everyone to introduce the specific solution! 1. Check if the wireless network card switch is turned on. There may be several ways to open the wireless network card switch. Here are two common ones. The first is to hold down the notebook's "Fn key" and the "wireless signal key", the wireless signal key can be found by referring to the figure on the right. There is also a switch with a wireless network card on the notebook, which can be found on the edge of the notebook, similar to the buttons in the picture below. 2. Diagnose the wireless network card In the control panel, go to “Control Panel\\Network and Internet\\Network Connections”, then right click on “Wireless Network Connection”, select Diagnostics, and then use WiFi Sharing after diagnosis is over. The master creates a WiFi hotspot. 3. Some computers can be turned on normally when using a wireless network, but once the computer is connected to the Internet, the network card cannot be turned on. Most of the problems that occur in this part of the user are caused by the power saving options set in the BIOS of the computer.  
Copyright © Windows knowledge All Rights Reserved