The meaning of the computer startup failure prompts

We often encounter computer startup failure or the computer system can not be successfully started, but the system feedback is all English information, then what is the meaning of those information prompts, let's take a look at the following article An explanation of these tips. 1, No boot sector on hard disk drive This situation may be caused by the boot sector on the hard disk is destroyed, generally because the hard disk system boot area has been infected with a virus. In this case, you must first use the latest version of the anti-virus software to completely kill the virus in the system, and then use the software with boot sector recovery function such as KV3000 to try to restore the boot record. If you are using a WinXP system, you can start the "Recovery Console" and call the FIXMBR command to restore the primary boot sector. 2, Hard disk controller failure (hard disk controller failure) This is one of the most common error tips, when this happens, you should carefully check whether the data cable connector plug is loose, the connection is correct or the hard disk The parameter settings are correct. 3. Reset Failed, Fatal Error Bad Hard Disk, DD Not Detected, and HDD Control Error. When any of the above prompts appear, they are generally It is the hard disk control circuit board, the hard disk interface circuit on the main board or the mechanical part inside the disk body has a fault. For this situation, only the professional can repair the corresponding control circuit or directly replace the hard disk. The failure of the computer to start up and the failure of the boot system startup is largely due to the hard disk failure, but it may also be due to hardware reasons. Therefore, when the computer fails to boot and the boot system fails to start, it should be done well. Prepare both hands. 4, Date error (data error) When this happens, the system reads data from the hard disk there is an unrepairable error or there are bad sectors on the disk. At this point, you can try to start the ScanDisk, scan and correct the logical errors of the sector. If the bad sectors are physical bad sectors, you need to use special tools to try to fix them. This article comes from [System Home] www.xp85.com