Solution that CAD can't fill

Some students may have encountered the problem of not being able to fill the graphics when processing CAD graphics. Here are three practical solutions:

First: This is mostly due to the filling of graphics. It is closed, which means that the graphic is open, so CAD cannot be filled.

Solution: Click the CAD chamfer menu to round all the segments in the graph one by one, and fillet radius input: 0. Then fill it up.

The second type: the proportion of the fill material is too large, in fact, your fill action has been executed, but because the fill ratio is too large, the gap in the fill material is displayed, the user thinks there is no The filling is successful.

Solution: Select the CAD fill menu, adjust the fill ratio (small trick: you can try to adjust from small to large, until fit), refill.

The third type: If CAD can't be filled, it's not caused by the previous two situations. It may be that the CAD setting is "Application Entity Fill" is not applied.

Solution: Select the “Tools” menu in CAD, select “Options”, and select “Show & rdquo; function” in the pop-up “Options” menu, in “Display&rdquo In the function interface, find "Apply Entity Fill", select it (mark in the box in the previous box), click “OK exit; you can also use the command prompt to open “ Application Entity Fill & rdquo; function, enter the letter "OP" in the CAD command prompt line, click Enter.

Summary: The CAD settings are not open. The application entity fills the function and the CAD graphics are not closed. This is the main reason why CAD can't be filled. You should check it carefully!