Win10 computer card? Win10 hard disk takes up 100% solution

Many netizens complain that after the computer system is upgraded to Win10, there will often be a stutter phenomenon. There are many reasons for the Win10 computer card, there are hardware aspects, such as the computer configuration is too low, the hard disk is too bad, and the system is mainly the service occupancy and other issues. The following "Computer Pepsi" network, mainly share the problem of the Karton problem caused by the high disk occupancy rate, this phenomenon is also more common.

Win10 computer card? Win10 hard disk takes up 100% solution

If you encounter a computer card, you can first open the task manager, and then view the "details", then you can see the hard disk disk occupancy, if it is The hard disk takes up more than 90%, and even up to 100%, there will be a computer jam problem, as shown in the following figure.

The following share the Win10 hard disk 100% solution, mainly to close some useless, but may take up the hard disk service, the specific operation is as follows.

1, close the HomeGrouListener service

First use the Win + R combination shortcut to open the run operation box, then type the name services.msc and click the "OK" at the bottom to open the service, as shown below Shown.

Running

After opening the service, then in the service project on the right, find the HomeGrou Listener service and double-click it to open, then change the startup type to disabled and click OK to save the operation. As shown below.

2. Shut down IPV6 network service

The network used by our computer is still IPV4, and Win10 has built-in IPV6 network, and it is enabled by default. In view of the fact that the current IPV6 network is still not used, it is completely possible to turn off the service that may occupy the disk. The specific operation is as follows.

First click the right mouse button in the network icon in the lower right corner of the Win10 desktop. In the pop-up options, click Open Network and Sharing Center and click on the connected network on the right to open the network properties, as shown below. .

Next, in the open network, click on the "attribute" attribute below, then find the IPV6 network, remove the previous default check (√), and click on the bottom "OK" to determine ” Save as shown below.

After closing the above 2 services, the problem of too high Win10 hard disk usage should be alleviated. If there is no effect, it may be that your computer configuration is too low or the hard disk has a problem. It is strongly recommended that everyone Replacing a solid state drive can effectively solve the problem of excessive HD10 disk usage. The following figure shows the disk usage after the small SSD replacement.

Upgrading solid state drives completely solves the problem of high disk usage

Because of the performance bottleneck of traditional mechanical hard disks, after upgrading SSD, it can effectively solve the problem of hard disk bottleneck and easily solve the problem of high disk usage. The problem.