Win7 system computer automatically restarts six major solutions

First, check the driver

First check whether it is caused by the graphics card driver, just started to have such problems, updated the driver from the official website of the video card There are no problems in the program for about half a month, so the problem caused by the graphics card driver is first of all to consider when we deal with such situations.

Second, check the system

After troubleshooting the driver problem, then we must consider whether the system is a problem, press the F8 to enter the windows advanced options menu interface and click the option "last correct configuration" ” Just enter the operating system, if this happens, the computer no longer has problems, indicating that the problem has been solved. (Note that some system settings will result in the last correct configuration can not be used, then it is recommended that you reinstall the win7 system)

Third, clear the dust inside the chassis

The above 2 steps can not solve the problem This is not a software or system problem. Next, use a screwdriver to open the chassis to see if there is a lot of dust inside the chassis. Use a soft brush to clean the chassis. After cleaning the dust, cover the chassis cover and turn it on again. The computer, if it is working properly, is ok.

Fourth, check the graphics card

The problem has not been resolved, enter this step, the graphics card problem is excluded, we open the chassis and gently pull the graphics card out of the motherboard, use a soft brush to remove the graphics card slot Dust on the board and gently wipe the metal strip of the card with the prepared eraser. After several times, the eraser and soft brush are found to be dark. After the dust is cleaned up, put it on and close the case.

V. Check the memory module

If the problem of cleaning the video card still exists, then we use the same method to clean the dust of the memory module. The dust is the nemesis of the hardware cooling. When the temperature is too high, the computer It will be in the protection hardware and restarted, so the computer has to work hard to clean up the hardware dust.

Sixth, check cpu

The last situation is that the computer has been used for more than a year, cpu silica gel may have dried up, then the cpu fever can not be passed through the silica gel to the fan to exclude, cpu temperature Too high, the hardware can not be activated when it is protected. Gently use the screwdriver to loosen the cpu fan screw, remove the cpu fan, apply the prepared silica gel on the fan metal surface and the cpu surface with your fingers, then install the fan and cover it. Chassis.