Windows 7 enable hotspot prompts can not start the bearer network how to solve?

At home, computers are rarely used, and basically only play mobile phones. At this time, WiFi hotspots are needed. In the absence of a router, the use of a notebook can be used to separate hotspots. Recently, when a friend uses a notebook to enable a hotspot, it is prompted that the bearer network cannot be started. How is this good? The following small series will introduce to you the solution to the Windows 7 open hotspot prompt can not start the bearer network.

Reason 1: Not open service

Solution

1, the most common reason for this. The solution is also very simple. First, open the Start menu, input cmd, into the command line;

2, the input netsh wlan set hostednetwork mode = allow, carriage;

3, the following tips that is successful;

4, and then re-open hotspot, success;

5, using a mobile phone Soso, is not it?

Reason 2: NIC driver does not support

Solution

1. Go online to download the NIC driver, it is best to find the corresponding driver for your computer;

2 can also be downloaded & ldquo; driver Genius & rdquo; or & ldquo; drive life & rdquo; such as driver software, a key scan case your computer-driven, online upgrade;

3, installing Restart the computer after the NIC driver.

The above is a description of the solution that Windows 7 can't start to host the network. There are two main reasons for this problem. You can also use third-party software to enable WiFi hotspots.