After the Win7 system is turned on, the solution of the entering power save mode appears on the screen

In addition to the use of other systems by individual users, everyone should use the Win7 system. No matter which system you use, it will have problems. No one can guarantee that the system you use will be 100% problem free. Some netizens feedback that after using the Win7 system, the screen will display the entertain power save mode. What is the matter? There are many reasons for the emergence of the enter power save mode. If there is a problem, there is definitely a solution. Below, I will introduce you to the solution of the enter power save mode of the Win7 system computer boot screen.

The specific method is as follows:

1. First, you can try to disconnect the data cable of the monitor after removing the power (remove the two fixing screws);

If the display enters the power-saving mode, it may not be received by the system. It is also divided into several situations and checked separately. For example, if you use the computer for a long time, you have never cleaned the chassis, and there are many dusts, which cause static electricity and power failure. Take measures: turn off the power and clean the chassis;

3, some brands have electrostatic protection devices, in case of such problems, first power off, then remove the power plug, then long press the power switch (or press A few power switches), power on again later, this will also clear the computer self-locking state;

4, there is a BIOS exception, such as the network boot mode, you can try to restore the BIOS default value . Power-on button (different computer keys have different values), usually the first interface will have a prompt for relevant key values;

5, some brand machines now have no key-value prompts, because a boot is displayed Brand logo;

6, for example, after some models enter the BIOS, find the Power Saving Mode in the POWER MANAGEMENT SETUP set to Disabled, then press F10 to save the settings to exit the BIOS, restart the computer;

7. If the setup menu is not found, you can restore the BIOS defaults (the steps will vary depending on the BIOS version). For example, the ASUS computer's BIOS is set to the factory default setting method: press the Esc key, find the Lood setup Defaults (some BIOS options are: Load Optimized Defaults Setting), press Enter to confirm;

8. If it is set by the monitor The problem (mostly happening in the desktop) can be set (or set to the default value) in the display's setup menu;

9. If there is a prompt at boot, but still can enter the system later, You can enter: powercfg.cpl → OK;

10. Set the device to be "Never" → save and modify.

The above is the solution for the enter power save mode on the Win7 system computer. If you have encountered the same problem, you can use the above method to solve it. I hope to help you!