Win7 system computer always press F2 to enter the system every time you boot

What should I do if the win7 system computer always presses F2 to enter the system every time? Win7 system encountered a boot failure problem is one of the common problems, I believe many users have encountered, such as win7 system computer always press F2 to enter the system every time you boot, how to do? Lead to win7 system computer always press every time you boot There are many reasons why F2 can enter the system. The following small series tells you three solutions.

Solution one:

1, the computer does not have a floppy drive or floppy drive failure, but there is a floppy drive in the BIOS, this situation will lead to F2 prompt;

2 In most cases, you only need to restore the BIOS default settings to restore normal;

3, some older motherboard default settings will also open the floppy drive, then enter the BIOS, please select the first item “ Standard CMOS Features 

4. After entering, set “Drive A” as “ None”,“Floppy 3 Mode Support” is set to “Disable”; Return to the BIOS setup main interface, select the “Advanced BIOS Features” option, press Enter to enter;

6. Set “Boot Up Floppy Seek” as “Disabled”;

7, press F10 to save, ESC key to exit the BIOS settings, restart the computer.

Solution 2:

1. There is a button battery on the motherboard to keep the BIOS settings and continue to run the motherboard clock if there is no power on, if this button battery This can also be caused by the absence of electricity. At this time, you first need to disconnect the power cable of the computer host and open the computer case;

2. Locate the button battery on the motherboard;

3. Use a flat-blade screwdriver to pry the battery down; Br>

4, re-install a new CR2032 battery;

5, close the chassis, connect the power cord, start the computer. Press the DEL key to enter the BIOS settings, restore the computer default settings;

6, save the settings and exit the BIOS, restart the computer.

Solution 3:

1. If the computer has dual hard disks or multiple hard disks, or an optical drive, when the hard disk or optical drive is directly unmounted from the computer, the settings in the BIOS are not available. Update;

2, the current computer motherboard generally has a hard disk drive automatic detection function, enter the BIOS settings, select "Standard CMOS Features";;

3, the hard disk and optical drive are set to Automatic detection is enough.

The content of the above tutorial is that the win7 system computer always press F2 to enter the system solution every time you turn it on. If you encounter the same problem, you can refer to the above tutorial.