Installation win7 system prompt "can not update the startup configuration" failure cause analysis and solution

installation win7 system prompts windows can not update the computer's boot configuration, the installation can not continue, resulting in win7 system installation can not be successful, the specific problem phenomenon as shown below Show:

Fault Cause Analysis:

This problem may be caused by the master boot record, so the repair method is also based on repairing the master boot record.

Solution:

1. Delete the previous 200M disk, and go to the c drive. Format the c drive. Repair the partition table. Rebuild the master boot record (MBR);

2, then the ghost system to the c drive;

3, or because your boot disk is not unplugged, the computer jumps from the boot disk to Hard disk boot, solution: After copying the file, remove the boot disk or set it as hard disk boot before restarting the installation.

The above is the reason for the installation of win7 system "can not update the startup configuration" and the solution to the full content of the introduction, after the installation, successfully installed win7 system!