win7 system, broadband access through ADSL PPPOE, but has not been connected, in the connection process, the broadband connection in the lower right corner will turn, wait until the prompt is not connected When you put the mouse in the lower right corner, the icon will prompt "Internet access - local connection display is not recognized". Unidentified network start (if this can be skipped normally), click on the customization below to see if it is public? Change to special-> Next-> Close (as shown below), OK, etc. After a while, there will be a window to choose the network situation, what family can be selected, what company, this depends on the individual's needs. (The icon can be changed at any time, the method is to customize after normal -> change). Wait for it to take effect for a while, because the computer should be automatically detected, use this time to set the IP. First click on the broadband and local view status, and select their IPv6 options (as shown below), this is the boot speed On the consideration, otherwise it will automatically get the IP segment that is not in contact with us every time it is turned on, it is a waste of time. (The education network should not be closed, other large telecom Netcom users should be closed, this technology It's too far away from us.) The IPv4 settings are as follows, IP address: 192.168.1.2 (to set this up, because the machine's IP address and the following gateway are on an IP segment), the subnet mask is automatically assigned 3 255 a 0, the address is: 192.168.1.1 (this is the default), about the next The IP addresses of the two DNS servers are changed according to the location. Each province or municipality has its own IP segment. It is recommended to use EVEREST Ultimate to view it, open it and click on the network device->Windows network to view the network configuration. The address of the device can be clearly seen, and then fill them into the preferred and alternate DNS respectively. This is almost the same, restart the computer and see if the connection is followed by a restricted connection, then open IE, Enter 192.168.1.1 in the address bar, press Enter, take the initiative to visit our ZTE ZXDSL831B ADSL Modem, well, have solved, perfect! Not yet, can not say that this is perfect, after the restart, the local connection has changed It's possible to be limited, and why do we have 2 network settings? Why can't we have only one? The answer is of course. And it's easy to add a pleasant one. The effect is as shown by clicking a custom, then clicking merge and delete. Network location, (pictured) then check ADSL broadband connection and local connection, point merge, then select the broadband connection in the next window, merge (that is, merge the local connection into the dial-up broadband connection). This will not Then there is a hint that the connection is limited.