Installation Win7 appears "Windows installer can't configure windows to be on this computer

            
Method 1:
When the above prompt appears, press shift+f10 to open the command window, enter the C:windowssystem32oobe folder, enter msoobe Enter, and you can enter the next step to enter the user name and password. .
At this point, the error prompt box is still there, ignore it. After entering the corresponding information according to the prompt on the screen, click the small red cross on the error box to close the dialog box. At this point, the system restarts, and the error is skipped until The system is successfully installed. After installing WIN7 system without any problems.
Method 2:
Go to the official website of intel to download the Windows 7 x64 F6 driver, which is the driver that can be added in advance during the Windows 7 installation process. You can add
to the steps of the installer to select or manage partitions. Method 3:
If you install the system, you may get stuck in one part. The prompt you said should be accurate. After the system is installed and restarted, it will enter the hardware detection and the corresponding driver start stage. It should be suddenly prompted: the windows installer cannot configure windows to run on the hardware of this computer. Then, It will enter an infinite loop, constantly reminding, and constantly reloading, no help. Therefore, each master has a high-tech, re-partition re-format; constantly change the system installation disk; and so on. The idea is correct, but it does not catch the key. Here are a few reasons: 1, mostly install win7, especially 64-bit. 2. Most of them use the new 2.5-inch 750G7200-rpm hard drive. 3. SATA Operation in the machine's BIOS option This option is used to configure the operating mode of the internal SATA hard drive controller. With these points, it is obvious that there are ways to solve the problem. The reason is to configure the working mode of the internal SATA hard drive controller. Because of the endless stream of new technologies, intercom, hard drive manufacturers, Microsoft. If the pace of follow-up is inconsistent, there will be a fight. In fact, it is very simple, nothing more than a patch of inter chip, such as inter F6 patch. In fact, seeing the 3 points I mentioned above, it is the easiest thing to start with the working mode of configuring the built-in SATA hard drive controller. First F12 or F2 enter the BIOS, depending on the model. Then select SATA Operation in the System Configuration option. Generally, you can choose ATA, AHCI, and RAID. Just choose AHCI. Do not choose Disabled. Save and exit.