Win8 can't start the security center service. How to do

Win8 can't start the security center service as follows:

The common reason for this error is caused by the security protection software installed in the computer, due to some security. The software comes with system cleanup and optimization functions, so it prompts to close unneeded services, etc. Users often find that the Security Center service cannot be started after optimization and cleanup.

Operation steps:

Option 1: Confirm the security center service settings according to the following steps

1. “Start”-“Run”Enter services. Msc and press Enter, find the Security Center, double-click, start type selection <;auto & rdquo;, service status selection “ start & rdquo;.

2. If the startup fails at this time, continue to enable the Remote Procedure Call (RPC) and Windows Management Instrumentation services in the same way as above, and then try to start the Security Center service again.

Option 2: Disable anti-virus software and firewall

1. Temporarily disable the security protection software in the computer and the third-party firewall program (for example: Kingsoft Internet Security, 360, Optimization Master, etc.) Then enable the Security Center service.

2, still can not start at this time, temporarily uninstall the anti-virus software, and then start the security center service.

Scenario 3: Clean boot in safe mode

After entering security mode, start the Security Center service according to scenario 1, and check whether it is successful. If the security center service can be successfully started in safe mode, You can use a clean boot method to troubleshoot program services that cause conflicts.

1. WIN+R calls up "Run", enter “MSCONFIG” hit enter, call up "system configuration", on the "General" tab, click &ldquo ; Selective start & rdquo;.

2. Under “Selective Startup”, click to clear the “Load Startup” checkbox.

3. Click on the “Services” tab, click to select the “Hide all Microsoft services” checkbox, and then click “all disable”.

4, click “ Enable & rdquo; tab, then click & ldquo; disable all & rdquo; and determine.

5, then click “restart”.