How does Win8 solve the problem that the Security Center service cannot be started?

The common cause of this error is caused by the security-type protection software installed in the computer. Because some security software has system cleaning and optimization functions, it will prompt to close unnecessary services, etc. Users often optimize and clean up. Found that the Security Center service could not be started.

Operation steps:

Option 1: Confirm the security center service settings according to the following steps

1. “Start”-“Run”Enter services. Msc and press Enter, find Security Center, double click, start type selection <;auto & rdquo;, service status selection <; start & rdquo;;

2, if the startup fails at this time, continue to enable Remote in the same way as above After the two procedures, Procedure Call (RPC) and Windows Management Instrumentation, try to start the Security Center service again.

Option 2: Disable anti-virus software and firewall

1. Temporarily disable security in the computer. Class protection software and third-party firewall programs (for example: Kingsoft Internet Security, 360, optimization master, etc.), and then enable the Security Center service;

2, still can not start at this time, temporarily uninstall the anti-virus software, and then start Security Center Service;

Scenario 3: Clean Boot in Safe Mode

After entering Safe Mode, start Security Center service according to Scenario 1, check Check if it is successful; if you can successfully start the Security Center service in safe mode, you can use a clean boot method to troubleshoot the program service that caused the conflict.

1. WIN+R calls up "Run", enter “MSCONFIG” hit enter, call up "system configuration", on the "General" tab, click &ldquo ; Selective start & rdquo;.

2. Under “Selective Startup”, click to clear the “Load Startup” checkbox.

3. Click on the “Services” tab, click to select the “Hide All Microsoft Services” checkbox, and then click “All Disabled”.

4, click “ Enable & rdquo; tab, then click & ldquo; disable all & rdquo; and determine.

5, then click “restart”.