Front panel no sound

1. After the Win8 system is installed, first look at the Realtek sound card installation is not the latest driver, if not, go to the official website to download the latest driver or use the driver wizard to download and install. 2. After the driver is installed, there should be an icon in the lower right corner as shown in the figure. Double-click the icon to open “Realtek High Definition Audio Manager” (If you don't have this icon, you can search for this file RtHDVCpl.exe, then start It also opens the high-definition audio manager.) 3. Open the “Realtek High-Definition Audio Manager” and click on the yellow folder in the upper right corner of the simulation, the rear panel, and then select “&” before disabling Panel Jack Detection > Click “OK”. After completing the above three steps, you can usually plug in the headphones or microphone with the front panel connector. Special case: In addition to the headset is broken, the motherboard front panel audio jumper connection is wrong. Instructions for using the HD Audio Manager Physical connection assignment settings: In the high-definition audio manager, you can see the settings on the right and left sides of the front and rear panels. The rear panel has 6 holes to indicate that the motherboard provides 6 channels after the chassis. Audio hole (if 3 is 3 channels), the hole is bright with color indicating that there is a physical connection, you can assign it by double-clicking the hole you connect, such as earphone, front speaker, audio input (do not want to Which device can make a sound, you can choose this). For example: Because I sometimes use headphones and sometimes speakers, I often plug in and insert trouble, so I put the [hole 3] in the first row of the computer into the earphone, then the second row [hole 2] inserts the speaker, the first The second row of [hole 3] is connected to the microphone, and the icon below is wrong. (As shown below), the high-definition audio manager is used to control the speaker pronunciation. When using the headset, double-click the 2 row of holes 2 and select “Audio Input” to silence the speaker. Similarly, a row of holes 3 can be set to "audio input" to control the headset to mute. If you use the rear panel to control the sound like the author, after opening the high-definition audio manager, click the yellow folder in the upper right corner of the simulation, the rear panel, and the top right, do not check “ disable front panel detection ”! Otherwise it will not sound. If you have a sound set as described above, congratulations! If you haven't estimated the same problem as the author: Right click on the front panel jack icon, the connector is reassigned, then the following selection of headphones appears, click & ldquo; OK & rdquo; get it, two holes, one headset, one microphone, Just try it.