Win7 system restore suddenly power failure can not start how to solve

For the use of notebook
small size, the user is also convenient to carry, but the shortage is that the battery can not be used for a long time, for the user usually For the operation and use of computer
, it is inevitable that you will not encounter the fault
problem that the system cannot operate normally. So many users will choose the "system restore" way to restore the original system. However, when a user restores the system using such a method, the sudden power failure causes the system to continue to be installed, and cannot be started at the same time. Such a system restore failure
How should we solve it?
1, using the system backup before power off to start the system restore, if there is no CD drive, it must be started through the U disk.
2, directly insert the U disk in the computer, if there is no hard disk, then you need to reboot to enter the BIOS settings, modify the SATA mode inside, and modify the previous "AHCI" to "Compatibility" or "Id"; IDE & rdquo It will be fine.

3, after re-reading the U disk, directly enter the PE to find the corresponding backup, and then use ghost to directly load and restore this backup.

4, if the computer has a blue screen, it is necessary to restart and then enter the bios, change the set "AHCI" mode, and finally restart directly.

When the Win7 system fails to boot or various problems, you can use the U God PE tool to install and solve. With the U God U disk artifact, we don't have to worry about system failure caused by system restoration, system installation, etc. The problem is.