Command line to create win8 boot disk

Run cmd as administrator, type diskpartDISKPART>

and enter: list disk select disk 1 clean create partition primary active format fs=fat32 quick assign

exit

Then copy all the files of the installation image into it

If it does not start properly, use the repair command: I:\\Boot\\Bootsect.exe /NT60 I:

Gone are the days, when we Used to burn CD and DVDs to install operating systems. Now all modern operating systems lets you install using PEN Drive /USB Storage Device /USB Stick. And this article describes step by step guide to format and create bootable Windows
Vista /Windows
7 /Windows
8 USB Stick.

Prerequisites:

Windows Vista /Windows 7 /Windows 8 ISO or installation filesA 4GB USB 2.0 Storage device (Its recommended to use USB 2.0 or USB 3.0 device for optimal performance)How To:

Plug your USB storage device. and run Command Prompt and execute the following commands one by one.DiskpartRun Disk partition utility < Br>

List diskTo get disk index that is used to perform disk partitioning.

Select disk nSelects disk n to perform disk partitioning. n is the number for your USB flash drive you obtained from above command.< Br>

CleanFlush your existing all USB drive’s partitions.

Create partition primaryCreates a partition as primary partition.

ActiveSet the partition as active to hold bootmgr.

Format FS=NTFS QUICKPerform a quick format on the USB Flash drive

AssignAssign a drive letter to the partition

ExitTo quit Diskpart utility

Now copy all setup files to USB Storage device… and that’s All.Re-boot your PC with it, you will be able to boot and install Windows Vista/Windows 7/Windows 8 using USB Stick.Note: If you face any trouble to boot with it or unable To boot, try this FIX.

I:\\Boot\\Bootsect.exe /NT60 I:Where I: is the drive letter of USB Stick
zh-CN"],null,[0.86308724],zh-CN"]]]