Win10 system how to set static ip win10 set static ip graphic tutorial

Win10 system Although compared with the previous system, the change is relatively large, many settings may feel very strange, but set the ip address and the previous win8, win7 almost. Now everyone goes to work, the computers used are all in the same LAN, everyone shares a network, this will involve the allocation of IP addresses. At present, most of our company computers get IP addresses dynamically obtained through DHCP. This is facing the problem of IP address conflicts. The following small series brings a static ip graphic tutorial to win10, so you don't have to worry about conflicts with other people's IP addresses.

Win10 sets the static ip method as follows:

1. Click the network icon in the lower right corner. In the window that opens, select “Network Settings”.

2. In the pop-up window, select the network card you are currently using. The small series uses the network cable to connect to the Internet, so it will display:

3. Select the relevant settings below. The Adapter Options & quoquo; will show all of our NICs that are in use and not enabled. Then select the NIC we are using now, right click and select Properties.

4. On the property card page that opens, select <;internet protocol version 4” then manually enter the static IP address we want to configure:

After inputting, click OK to save.

After setting your static IP through the above method, then this IP address is what you have been using. If someone else configures this IP address on other computers, it will prompt him "IP address conflict" ;, others will not configure the IP address we are using.

The above is a brief description of the static ip graphic tutorial for win10. I hope to help everyone. If you have any questions, please leave a message, Xiaobian will reply to you in time. of. Thank you very much for your support of this website!