How does the WinXP system use the Tracert command? WinXP system using the Tracert command method

How does the WinXP system use the Tracert command? What is Tracert, I believe everyone should know about it! Tracert, also known as the Windows Route Tracking utility, can be used to determine the path selected by an IP packet access target at the Command Prompt (CMD) using the Tracert command. So how do you use the Tracert command? The following small series will bring you the WinXP system using the Tracert command, let's take a look.

The method/step is as follows:

In the first step, click on the bottom left corner to start.

The second step, continue to click to run.

The third step is to pop up a dialog box.

The fourth step is to enter the command cmd.

The fifth step is to pop up the DOS window.

Step 6 Enter the command Tracert+ domain name as follows.

The seventh step, the return results are as follows.

If you don't know how to use the Tracert command, you can refer to the above method to try it out! The operation is very simple, just follow the above steps to operate. The above is the method of using the Tracert command in the WinXP system brought by Xiaobian. I hope I can help you. For more content, please pay attention to this website!