Windows10 prompts “client mac addr:..” after the boot, the specific phenomenon is as follows:
The reason for the failure:
This is because the NIC is enabled in the BIOS and is The first startup item, or the computer does not detect the hard disk.
Workaround:
If your computer can't enter win10 system, then you need to check whether the hard disk is connected properly, whether the hard disk is damaged or not. If you can enter win10, it will only display the network card boot interface, then you only need to close the BIOS. The network card can be started.
Specific setting method:
First, the example BIOS one, blue interface:
1, first boot continuously tap the Del or Delete button on the keyboard to enter Bios, select Onboard Device in Integrated Pripharals, Set the LAN BOOT ROM to Disabled, and finally press F10 to save and exit, as shown below:
2, some motherboards are (for example: K8M800) boot continuously on the keyboard. Del or Delete button to enter Bios, select Integrated Pripharals to enter, you will directly see an option to "Onboard LAN Boot ROM /Onboard NIC boot", turn this off, as shown:
3, there are some models of the motherboard boot continuously hit the Del or Delete button on the keyboard to enter the bios, select the Onboard Device in the Integrated Pripharals will see the name "Boot from onboard Lan /slave board" The option to enable the network card to start, turn this item off, as shown in the figure:
4. Adjust the first boot item to the hard disk. Press the Del button to enter the bios and click Advanced Bios. Feature option, as shown:
After clicking the Advanced Bios Feature option, you will see the option of 1st boot device. This is the adjustment option of the first boot option. After double-clicking, select the Hard Drive option in the pop-up dialog box, as shown in the figure: Br>
Second, the example BIOS 2, gray interface
1, first boot continuously hit the F1 button on the keyboard, enter Bios, click the Devices option, then click Network Setup to enter , PXE Boot Agent: can be changed to Disabled, and finally press F10 to save and exit, as shown below:
2, there are also some motherboards (for example: AMD 690) models, boot Press f1 to enter the BIOS interface, click the “Advanced” option, you can see the “OnBoard Device Configuration” option. After clicking, you will see the option named “PXE boot Rom”, and you can close this item. As shown in the figure:
Change the startup method, enter the bios, find the BOOT option, click the Primary boot sequence option to enter, change the 1st boot device option to hard drive Start up as shown:
Three, ThinkPad models, horizontal board BIOS interface, turn off the network boot and adjust the hard disk as the first boot item method
1, you boot continuously hit the F1 on the keyboard Press the button, select the Config option, click on the Network option, enter the Ethernet Lan Option ROM option, select Disabled;
In addition, if you do not need Wake on LAN You can also change the wake on LAN to disable, as shown in the figure:
2, ThinkPad models, press f1 to enter bios, select the Startup option, then click boot to enter According to the illustration, adjust the startup item (ATA HDD option is hard disk), as shown in the figure:
The above is the prompt for Windows10 after booting "client mac addr:. .” The cause of the failure and the solution of the whole content, there are more BIOS, you can refer to the above to find the location and then turn off the network card to start, let win10 system start faster, friends with this problem can Set the solution according to the above method.