In the installation of win10 preview version 10041 prompt uefi hard disk problem can not be installed to solve the tutorial

A lot of users have installed the win10 preview version 10041 when there is a prompt that can not be installed, what should I do? Here and Xiaobian to see the uefi hard disk problem can not be installed to solve the tutorial.
>> How to install win10 official version of the installation tutorial win10 system video installation tutorial

Many users are ready to install and upgrade Win10 preview version 10041, the system prompts "due to the user computer there is an unsupported for The hard disk layout of the UEFI firmware, so the system cannot be installed. According to Microsoft's reply, this problem is due to the addition of the UEFI detection mechanism in the new version of Win10, in case the "hard disk loss" in Build 9879 occurs again.

But at the moment, some of this mechanism is "overkill" and many computers that should not be blocked are refused installation. After this problem appeared, the Microsoft community gave a solution that solved the problem by creating a Microsoft Reserved (MSR) partition.

The steps to create an MSR partition are as follows: 1. Enter CMD in the Cortana search field, then run in administrator mode

2. Enter diskpart.exe and press

3 Enter the List disk command and press

to determine the next operation according to the number of hard disks displayed on the screen.

If there is only one hard disk:

1. Enter the List volume command and press

2. Select the drive letter with the boot partition (usually C drive), remember Volume number

3, run command

Select volume X (X is the number remembered in the previous step)

Shrink desired=50 minimum=40

Create partition msr

4. Enter the command List partition to confirm whether the MSR partition is created successfully

After successful, exit the program.
>> win10 preview version 10036 download address win10 10036 official website download

If you have more than two hard drives, you must first confirm the partition of Disk 0 (simple understanding of the first hard drive, counting from 0) Situation,

1. Enter the following command:

Select disk 0

List partition

Select partition 1

Detail partition

2. According to the obtained partition details, determine whether it is a C drive (boot partition) and an NTFS partition. If so, follow step 3; if not, enter the following command to check the next partition:

Select partition 2

Detail partition

and so on, until You have determined that the partition is boot partition and /or NTFS format.

3. Enter the following command:

Shrink desired=50 minimum=40

Create partition msr

4. Enter the following command to confirm whether the MSR partition is Created successfully:

List partition

Exit the command prompt after success.

Not only that, you can also confirm that the partition was created successfully by running the disk management program (enter diskmgmt.msc in the Cortana search bar). The MSR partition should appear at the end of the hard drive list.

Note that this method has certain risks. It is best for users to wait for the next Win10 version to solve the problem.
>> win10 preview version 10041 download address win10 10041 official image download