WinXP optimization tips to turn off redundant useless interface devices

Due to its many advantages, WinXP system, even if it is stopped by Microsoft, there are still many users using it. Many low-profile computers use WinXP as the preferred installation system, but many users are still not satisfied. Configure it for optimal performance, where turning off redundant interface devices becomes a key goal.

WinXP has many interfaces, compatible with various external interfaces, and its own driver including standard interfaces such as USB1.1, IEEE1394, and PCMCIA is one of its advantages. However, there are also many interfaces that are useless. For example, the Ethernet interface is used the most, and the infrared interface is rarely tested. As for the PCMCIA interface and the 1394 interface, it is never used.

What we mean is "interface", which is essentially a device. In order for these devices to work in the operating system, you first need to load the drivers, take up system resources, and secondly consume power. But if you don't need it, isn't it costless? For a PC, it takes a little bit of power to make a few interfaces, but for a notebook, it saves you money.

To turn off devices that will not be used for a while, it is most convenient to operate in the device manager. Here we can "disable" and disable the parallel port, serial port, floppy disk interface and 1394, infrared interface, etc. Just a little bit, we can shield the sound card when we don't listen to the song —— this is not too much, the notebook configuration is AC`97“soft”sound card that needs CPU service, its resource occupancy rate when sounding Not too small.

To achieve the shutdown of some devices as described above, make adjustments in the BIOS to be more thorough; but through the device manager to operate, one is simple and convenient when shutting down, the two need to be re-enabled More convenient, even restart WinXP is free.

Closing some unnecessary system services is also a common method of squeezing the last system performance. Some services are directly connected to the interface device, such as the Infrared Monitor and Smart Card used to display the infrared connection status. service. The former is used to display the status of the infrared device connection, and the latter is used to manage the smart card, so that some services actually do not have much practical effect. We set the startup property to “Manual” to save system resources.

There are also services such as Messenger, RPC, and Remote Registry that are of little use, but are the most vulnerable. They are also set early as “ manual & rdquo; mode is wonderful.

Turning off some of WinXP's interfaces that don't have much practical effect can not only save system resources, but also completely change the running speed of WinXP. It is a big benefit for many users of laptops, if you I feel that this tutorial is easy to use and welcome to share more friends.