What should I do if the black screen or connection fails when winxp and win8 are connected to the remote desktop?

xp and win8 for remote desktop connection, the system difference brings some new problems, the following common xp connection win8 system remote desktop black screen or other failure reasons analysis and solution.

1. Check if Win8 has Remote Desktop enabled: Desktop -> Right click on "Computer”-> Properties-> Remote, as shown below, confirm “ Allow remote connection to this Computer & rdquo; has been selected.

2, check the services required to open remote desktops in win8

Press the "win+R" key, start “Run”command, enter: services.msc, view Local service. Check if the three services Remote Desktop Configuration, Remote Desktop Services, Remote Desktop Services UserMode Port Redirector are started. (At least the first two are required)

3. If you set up a remote connection in win8, you need network level authentication. Since xp is not enabled by default, when xp is connected to win8 remote desktop, It will appear that the client cannot establish a connection to the remote computer & error; Therefore, if there is no special requirement, you should remove the selection of the computer connection that only allows the remote desktop using network level authentication to be checked in win8.

4, other settings problems:

The system default blank password policy will prevent the blank password account from connecting from the network, please set the password for the remote login user. The guest account is blocked from the network connection under the default security policy. After connecting to the remote interface, you can activate the remote desktop task manager, then log out the account you have logged in, and then quit and re-connect to log in once. To activate the Task Manager in Remote Desktop: press Ctrl+Alt+End. Note that this End key is not the End on the keypad, but the one above the arrow keys.