with Ghost software; the management of the public computer room has always been a headache. Due to the large number of people on the machine and the high density of the machine, once the system is destroyed, it will not only be time-consuming, laborious, but also affect the use. At present, the commonly used method is to protect the hard disk file. There are two common methods: hardware protection method and software protection method. The hardware protection method needs to add hardware card, although the protection effect is good, but the cost is large, and the overall performance of the computer system often has obvious negative effects; the basic idea of the software protection method is to add write protection function to the hard disk by software, at the cost. Smaller, has no obvious impact on the performance of the computer system, but the protection effect is often not satisfactory.
In the actual public room management, according to the characteristics of the public machine room (such as the relatively concentrated machine, the number of similar machines, etc.), the author uses the hard disk protection program plus Ghost software to better solve the effect and The contradiction between the costs. This method can be used for both quick recovery systems and quick installation systems.
Make a hard disk image file;
First, select a machine, divide the hard disk into two (or more) logical disks, and properly install the required software on the C disk, including the hard disk protection program. . ;
Then, in Windows, make the necessary parameter settings, such as selecting "System" in the "Control Panel", in the "System Properties" dialog box that pops up, select the "Virtual Memory" button of the "Performance" tab, set Make the virtual memory D disk. The software on the C drive is considered public software and is not allowed to be modified, deleted, or added. The D disk is a public disk for the user to use. The public software installed by the author has a capacity of about 1.3GB. ;
Finally, do the following:;
● Prepare the Windows boot floppy (with CD-ROM driver), and copy the Ghost software on the disk (I used the 6.0 version)
● on the machine Add a hard disk to store the image file of the first hard disk;;
● Start the machine with the Windows boot disk and run the Ghost software (Note: Do not run the Ghost software in the Windows environment, I found that in the Windows environment Run the Ghost software to create an image file. In the future, you should also perform the Windows environment. ●;
● Select “Disk” under the “Local” menu, then select the “To Image” option and select the image file according to the prompt. Object hard disk (such as C disk), select the disk file (such as D disk), image file name (such as GX110XT), extension (default is GHO), select "higher" option in "compressed window", so The generated C disk image file size is approximately 560MB. ;
● Burn the image file GX110XT.GHO to the disc.
After the above process, the public software and C disk partition information are all contained in the image file and stored on the CD. Since Windows needs to detect the hardware and install the corresponding driver during installation, it is often necessary to create a corresponding image file for a certain model.
Quick installation and recovery system;
With the corresponding image file and boot floppy disk, you can quickly install and restore the system as follows:
● Start the computer with the boot floppy disk (even the system on the C drive) Fully 瘫痪 also applies);;
● Run the Ghost software on the disk;;
● Select "Disk" under the "Local" menu, then select the "From Image" option, and then select the image file according to the prompt ( Such as D: GX110XT.GHO) and the target disk to be released (such as C drive);;
● After running the hard disk saver, the whole process ends.
The author actually installs and restores a machine in about 6 minutes, which is equivalent to the "cloning" method of the hard disk to the hard disk.
Using Ghost software to quickly install and restore the system features no need to disassemble the computer and hard drive, and the speed is fast and the operation steps are simple. The method provides a quick and convenient means for software installation and system recovery of a large number of machines in a public machine room.