Graphic analysis: replace the computer hard disk without reinstalling the system

The computer will inevitably encounter the problem of aging parts, such as my own computer, Samsung's desktop has 8 years of history However, although the time has been a long time, but its parts can basically meet my needs for office needs, but that 80G hard drive is really unbearable, not only the sound is huge and the reading speed is slow. As for the system, it was installed five years ago and has been used until now. Because of the card-swapping software, there is a dongle in it. Reinstalling the system means that it costs a thousand yuan for maintenance and cannot be installed successfully. Really a headache, tried 360, Windows optimization master, optimized N times, still the same, and later under the guidance of a computer expert, the hard disk update. Now share this method with everyone.

First, prepare the work introduction.

You need to prepare a new hard disk first. I use a Seagate 40G hard disk to work on the new hard disk and give the 70G old hard disk data to Ghost. According to the number of partitions of the old hard disk, the size of each partition only needs to exceed the size of the data stored by the old hard disk.

Next, look at the steps with your eyes wide open.

1. Install the hard disk that needs to be replaced in the chassis. Pay attention to the jumper, the first hard disk jumper Master (main disk), and the hard disk that needs to be replaced to jump the slave (slave). Go to Ghost and select Local—Partition—To partition. As shown below:

2. There are two hard disk interfaces. Remember the size of your two hard disks, that is, the 76G hard disk is copied to the 38G hard disk. The brain should be awake to avoid misuse. We are here first. Select the first hard drive, which is the 76G hard drive as the source image. As shown below:

3. The figure shows that there are 5 partitions in the 76G hard disk. The fifth partition is a one-click recovery wizard. I uninstalled it for a few years and did not uninstall it. It is up. We first select the first partition, which is the 8G C drive. As shown below:

4. After selecting, the following figure is displayed. At this time, the second 38G hard disk is selected as the directory image disk. As shown below:

5. Select the first partition of the 38G hard disk as the target partition image. As shown below:

6. We have a familiar interface, just wait a few minutes. As shown below:

Finally, the same steps are set.

1. After the completion, it will automatically go to the location of the second image, we can then copy to the D, E, F partition image to the new hard disk, the same steps as the C drive.

2. After all is completed, turn off the IDE cable and power cable of the old hard disk, jump the new hard disk into the Master (main disk), and then boot the same system, the same information, but appeared One problem is that software that is not a system disk can't be used.

3. Check it out, the original disk is chaotic, D, E, F display becomes J, H, I. Enter the disk management in the management and modify the drive letter.

4. Restart, the data of the old hard disk is copied more completely, and all software is used normally.

Although the above steps are more complicated, they can save us a lot of money. When you update your hard drive, you don't need to reinstall the system. It's heavy and light, and you will make the most savvy choices.