How to solve the problem that the computer memory stick is easy to loosen

For the memory stick of the computer, I believe everyone should be very familiar with it. We all know that in normal times, the memory stick is generally not used for management, but as the computer is used for a long time, the chassis will have a lot of dust, or the memory strip will be loose due to the movement of the chassis. Then, when the computer memory is loose, how should we solve it?

Under normal circumstances, the memory module will have the following phenomena:

Phenomenon 1: After the boot, the display is dark The chassis emits a long sound of "dot & mdash;, mute & mdash;".

Phenomenon 2: After booting up, the display interface stays on the boot screen (cannot enter the system desktop) and restarts continuously.

Phenomenon 3: After the power is turned on, the display is still dark in the state where the display is in good condition, and there is no sound other than the fan turning inside the chassis.

The cause of the failure:

The looseness of the memory module is generally caused by accidentally hitting the chassis or indoor humidity and dust during handling of the chassis.

How to solve the problem:

First of all, you must turn off the main power of the computer, and if you do not turn off the power, it will easily damage the computer memory.

Next, use a Phillips screwdriver to open the case, and fix the motherboard to the ground level to find the memory location.

1) Touch the metal case of the chassis or the metal water pipe (put off the static electricity on your hand).

2) Press the ends of the memory stick with both hands and shake it with a little force. .

3) Turn on the main power of the main unit and see if the computer can start normally.

Note: If this still does not work, turn off the main power again, and gently press down the white tabs on both sides of the memory module slot to make the memory module pop out of the slot. Hold the two ends of the memory stick, align the slot and the bayonet position, and use one force first. Then hear the sound of “咔—” and then force the other end until “Ä咔—”” appears again. Next, turn on the main power of the main unit to see if the computer can start normally. If it is still an old phenomenon, you have to change the memory module slot (there are two or three general memory module slots), and then repeat the steps of “Note”.

Finally, if it is not processed through the above steps, it may be the reason of the memory module itself. The removed memory module should be replaced by the merchant to buy a matching memory module.

If you have any of the above three problems after the boot, you should first consider whether there is a problem with the memory module. In fact, you only need a few simple steps, you can easily deal with the problem of how to solve the problem when the computer memory is faulty.