About the introduction and analysis of notebook cooling problems

Heat dissipation plays a decisive role in notebooks. If the heat dissipation is good, it can help your notebook to run and use better, and it can better protect the CPU and some hardware. Therefore, the quality of heat dissipation is often a problem we are concerned about, but I often hear people say that the heat problem only exists in the game book. Like the business itself, the heat is small and there is no heat dissipation problem.

But this is not the case?

Some laptops with unreasonable design have a large amount of heat, let alone play games, that is, keyboards, hard disks, CPU fans can be felt when surfing the Internet. The area is very hot, even hot, the fan is still working all the time, the noise makes the hot summer more restless, the outside is so hot, the inside of the book? The temperature may have reached the forbidden line range, you Don't worry?

Laptops are also electronic products, and their useful life is not endless. Working in a good environment can greatly extend the life of the notebook.

Temperature is the most important point of environmental factors. Excessive temperature will cause electronic components to age and scrap, so no one wants to see them.

A lot of laptops are cost-limited (price competition is too fierce) and design process reasons, these defects are consumers to pay, the cooling module is not very good, cooling capacity is limited, usually work Can cope, summer is not enough, there are problems with poor heat dissipation, although there are emergency shutdown treatment.

But looking back and thinking about it, you have just written a two-hour plan, novel, and graduation thesis with your own books. At this moment, you suddenly shut down and shut down, you have not had time to save, just like this. If you don't have time to start from scratch, what do you think?

Let's share why the notebook is not well cooled, or even bad!

The reason why the notebook is not good. :

1, CPU heat is large and CPU cooling device cuts corners (the manufacturers have to do this because of the pressure of market competition and price wars, the original use of large pieces of pure copper, now shrinking the volume and even using aluminum) The result is that consumers come to pay the bill, once the problem has passed the warranty period, they have to pay for the repairs left by the manufacturer. These are the problems left by the manufacturer. The reason is that the market competition is cheaper than other manufacturers.