How to solve the problem that the target volume cannot be locked when installing the system?

Recently, some users have reported an error when installing the ghost version of the system, and an error window pops up, prompting "a destination volume could not be locked", which caused the Ghost installation error. What is going on? How to solve this problem? In fact, we just need to close all other programs and restart the computer. The following small series introduces you to the solution that the target volume cannot be locked when the system is installed.

encounter this problem causes Ghost installation error, according to prompt the contents of the display, meaning roughly as & ldquo; the target volume can not be locked & rdquo ;, therefore we just find the corresponding method will allow the installer to proceed .

Operation steps:

First of all, in order to avoid the problem, we will close all other programs, because it may be that the use of other programs occupies the target volume, which makes it impossible to lock. Before the installation, some users opened the DG partitioning tool, and the tool took up the target. We can bring up the Task Manager, the program will shut down all non-system, as shown in Figure:

To ensure success, after we close the program and then restart the computer, do not open into the other unrelated The program is installed directly, and it should be able to install smoothly.

Of course, the final method is to use the U disk boot disk to enter the PE system, format the target disk to be installed, and then re-install the system, I believe that there will be no error message that the target can not be locked.

These are the small series of solutions target volume can not be locked when installing the system introduced for everyone, if you encounter more such cases, try the above steps try and see.