How to install Win 2008 32/64 bit on hard disk

It is best to start under PE. The 64-bit installation 32-bit installation method is basically the same, except that the 32-bit installation omits the 32-bit bootsect.exe step. Use the virtual CD-ROM software to extract the 64-bit installation files to the hard disk such as f:\\x64\\ Copy the F:\\X64\\boot directory to the C:\\F:\\X64\\bootmgr file to C:\\ and then in the C:\\New directory sources Copy F :\\X64\\sources\\boot.wim file to this directory. Find a 32-bit bootsect.exe and put it in c:\\. Execute c:\\bootsect /nt60 under CMD command c: bootsect.exe is used to configure the boot environment, which is the boot menu. If you are not assured, you can replace it with the 64-bit bootsect.exe in the boot folder after executing the command. 1. The serial number is definitely needed. After restarting, Windows Setup will appear, and the next step will be selected. 2. After the installation interface appears, click Next>Repair your computer>Next>Click Command Prompt 3. Run format c:/fs ntfs /q c drive, or 4. Enter the command " c: " (assuming the original XP is installed on the C drive) Then enter the following command (necessary, otherwise failed, personal experience) del bootsect.exe del bootmgr del boot del efi del sources (if the deletion fails, Then the file is likely to be hidden, such as bootmgr, then you need to remove the hidden attribute and then delete: " attrib -s -r -h bootmgr ", try again. Those subfolders should not be managed) After deleting, start the installation: f:\\x64\\SOURCES\\setup.exe