How to deal with the monitor after WinXP starts?

Recently, some WinXP users found that after starting their own computer, the display has no signal, and when the startup starts, you can see the startup progress bar, and after the startup, the host runs normally and the hard disk light flashes. Today Xiaobian tells everyone how to solve this problem.

Recommendation: WinXP Professional Installation Download
Solution:
1. Check if the monitor does not work because the monitor refresh rate is too high.
Restart the system and press F8 to see if it can enter safe mode. If you can enter, please set the refresh rate of the monitor to a lower level:
Right-click on the desktop and select “Properties> in the Open Settings window. Select the “Settings' tab, click the “Advanced" button, select the “Monitor> tab, and set the refresh rate to 60 or lower.
2. If the system is still not working properly after restarting the system, please check if there is a virus in the system. Some viruses will cause such a fault after infecting the system.
3. In addition, please try to re-plug the memory card and the card device, sometimes there are various failures due to loose hardware.
The above is the solution after the WinXP computer starts, there is no signal on the display. If you have any problems with this kind of problem, you can try to fix these methods introduced by Xiaobian.