Expert analysis start winxp system press F1 to enter 13 tips

Start winxp system press F1 to enter, the reason is that your BIOS settings have problems, this may also be abnormal boot system, is a fatal system failure, if you press F1, do you continue? What?
1, restart the system, enter the BIOS settings, found that the floppy drive is set to 1.44M, but in fact there is no floppy drive in the chassis, set this to NONE, troubleshooting.
A lot of people have asked such questions. I will summarize the problems I have encountered in the following, and I hope to help you.
2, Hareware Monitor found an error, enter POWER MANAGEMENT SETUP for details, Press F1 to continue, DEL to enter SETUP
Chinese: Monitoring function found error, enter POWER MANAGEMENT SETUP to view the details, press F1 to continue booting Program, press the DEL key to enter the COMS settings.
Explanation: Some motherboards have hardware monitoring functions, which can set the temperature monitoring of the motherboard and CPU, the voltage output level monitoring of the voltage regulator, and the monitoring of each fan speed. When the above monitoring function is turned on When you find an abnormal situation, then the above paragraph will appear. At this time, you can enter the COMS setting and select POWER MANAGEMENT SETUP. On the right, **Fan Monitor**, **Thermal Monitor** and **Voltage Monitor** Which part of the exception was issued and then resolved.
3, pri slave drive-ATAPI LNCOMPatible press F1 to Resume
It may be that your CD-ROM drive is not connected or faulty. It is best to set each IDE port to automatic in CMOS.
4, cpu has been changed please re-enter cpu settings in the cmos setup and remember to save before quit!
Some of the motherboards have a FSB jumper, the default is 100MHZ, and some motherboards do not support auto-frequency modulation You just need to set the FSB to your CPU standard FSB in the BIOS. The multiplier is usually set automatically. It is best not to overclock.
5, Press F1 to continue, DEL to enter SETUP
After booting, press DEL to enter BIOS, select NONE in the floppy drive and press F10 to save it