How to install the system for the netbook-U disk boot installation system

Preparation:
1, U disk or memory card above 1G
2, UltraISO-U disk system file writing tool
3, system installation file
4, Hash V1.4-MD5 verification tool
After downloading the system, use Hash to verify MD5 (open hash.exe and drag the system installation file into the window)
The following begins to explain how to use U disk Make the boot disk installation system
First step, double-click UltraISO.exe, then open the system file you just downloaded
Step 2, insert the USB flash drive or memory card, select “Start CD-Write Hard Disk Image&rdquo ;
The third step, select the write mode, make the boot disk (back up important data before writing). There are two modes: USB-ZIP and USB-HDD. There are different modes supported by the motherboard. In most cases, USB-ZIP is supported.
Select “ is & rdquo; to continue writing data
The fourth step, after the production is complete, you can start to install the system. Insert the USB flash drive into the netbook and turn it on. Press DEL (or F2) to enter the motherboard CMOS settings when booting. Set the first boot device to USB or removable device. You can start it successfully.
Step 5, start with U disk. Enter WINPE, the new book must be partitioned first, then double-click the "automatic installation system" in the lower left corner of the desktop,
sixth step, press any key to start copying the system, the system will automatically restart after copying.
Note: When the system restarts, you must dial out the U disk.
The system will automatically deploy and install after restarting, including common software and hardware drivers will be installed automatically.