Reinstalling XP system encounters blue screen code, several tricks solve you no longer worry about

The reinstalled system is XP system, but after rebooting after installation, it is found that as soon as you enter the system, it will prompt blue screen code 0X000000A5, this type The code hints are 0X00000002, 0X81A53008, 0XE13291A0, 0X81A4C770. What does this blue code mean, why is this prompted? How to solve it? At this moment, you must be as eager as the ants on the hot pot. If you want to solve this problem quickly, you may wish to read the next article carefully.

What is the blue screen code?

The blue screen code is usually caused by the motherboard BIOS not fully supporting the ACPI specification, or because the graphics card is loose, the golden finger is oxidized.

Blue Screen Code Solution:

1. If there is no corresponding BIOS upgrade, then when installing Windows 2K/XP, when "Pursing F6 if you need to install a third-party" SCSI or RAID driver” When prompted, press F7, so Windows will automatically disable the installation of ACPI HAL, and install Standard PC HAL.

2. If the blue screen code 0X000000a5 appears when installing the system, because The key recovery program requires ACPI support, so you can replace the system installation or install the driver with a new version of the system.

3. If the graphics card is loose or the golden finger is oxidized, try again after plugging it again. If it is not possible, you will have to replace the graphics card.

Other solutions:

1. Comprehensive detection of virus Trojans and malicious plugins.

2, after the power is off, open the chassis to clean up the dust, check all connections, especially the memory, unplug the memory, clean the pins and re-insert them; if it is a separate graphics card, the same way.

3, run chkdsk /r at the command prompt to repair the partition where the system is located; the command is executed when restarting, blue screen white, do not interrupt.

4, set the virtual memory to a partition with a large remaining space.

5, set the BIOS to the factory defaults; in the BIOS set the "ACPI Suspend Type" in the power management settings to S1 (some machines display STR) or directly close the ACPI option.

6, with the driver wizard 2011, update the motherboard, graphics card, sound card, network card driver.

In order to solve the problem in essence, the key is "the right medicine", the appearance of the blue screen code, we must first check what is the cause, and then solve the problem according to the reason, to find the best solution is The key to quick resolution, the detailed resolution of the above steps and the reasons for the details, I believe that you can bring a light to the blue screen code, so that you no longer worry about the blue screen.