Mouse failures require people to teach you how to solve problems

We often use a device that is a mouse. If there is a problem with the mouse, it is almost impossible for some users to die, and the mouse is also a lot of faults. If you don't pay attention to the problem, the following is Common faults and solutions for mice.

The mouse is one of the most important devices in a computer hardware device. Once the mouse is not working properly, the computer system cannot be operated conveniently and quickly. The following are common faults and solutions for mice.

1. Afraid of the mouse

Phenomenon: A computer in the office, the mouse sometimes does not move. The connection is very tight. Later, I found that when I opened the curtain, the mouse did not move. Closing the curtains works fine, but the mouse does not use a special mouse pad, so there is reason to think that this is not an optical mouse. Is the mechanical mouse afraid of light?

Method: Apply black paper inside the mouse. Steps: Turn the mouse on after turning it off, use the 5-inch disk write-protection label or black out the sticker, and stick it in the most leaky places inside the mouse. Note that the paper should be long so that the paste is firm. Note: Some mice are semi-mechanical and semi-optical, and the appearance is the same as a mechanical mouse. Because the mouse is cheap, consider buying a new mouse.

2.Moving problems

Phenomenon: My old mouse was sent by someone else. It is said that I spent 500 yuan to buy it in the past. It is very good, but recently it’s more difficult to move. Actually this I haven't moved for two days. It can't be used on other people's computers, and it can be used occasionally.

Method: Clean the inside of the mouse. Step: Shut down, rotate the O-ring on the back of the mouse in the direction of OPEN, and take out the ring and the ball. Wash the ball clean, dry it with a lint-free cloth or allow it to air dry. Use a sharp knife or the like to gently scrape the dirt in the middle of the two sticks inside the mouse. Then use the leather tiger or vacuum cleaner to suck the inside of the mouse, put the ball in it, and install the O-ring in the opposite direction. Note: The mouse and mouse pad should be cleaned regularly. Note that the mouse is usually used in a clean place, and it is often found that someone uses the mouse on a dirty desktop.

3. The serial port is not enough

Phenomenon: There is a mouse and MODEM on the serial port. Now I want to use a serial port plotter. What should I do?

Method: Use PS/2 mouse or built-in MODEM or USB mouse. Step: The USB mouse does not require a driver with the mouse. Moreover, it can be hot swapped and can be installed and removed without shutting down. After the USB mouse is plugged into the flat USB port of the computer, Win 97/98 will automatically detect the device. Just follow the prompts to insert the system installation disk. Note: After changing to PS/2 mouse, it gives up a serial port for the plotter to use. If there is no PS/2 interface on the computer, you can only change the built-in MODEM. But it is cumbersome to set up, you can't use interrupts 3 and 4, and the addresses can't conflict with them. USB mouse does not occupy the COM interface, most 586 computers, all 686 computers support USB mouse. But the 586 computer requires a USB interface accessory. Win 95 does not support the USB interface.