How to install the system for the netbook-U disk boot installation system

Preparation:
1, U disk or memory card above 1G
2, UltraISO-U disk system file writing tool
3, System installation file
4, Hash V1.4-MD5 verification tool
After the system is downloaded, use Hash to verify MD5 (open hash.exe and drag the system installation file into the window)
Using the U disk to make the boot disk installation system
First step, double-click UltraISO.exe, then open the system file just downloaded
Step 2, insert the U disk or memory card, select “ Start CD-Write Hard disk image”
The third step is to select the write mode and make a boot disk (back up important data before writing). There are two modes: USB-ZIP and USB-HDD. There are different modes supported by the motherboard. In most cases, USB-ZIP is supported.
Select “ is & rdquo; to continue writing data
The fourth step, after the production is complete, you can start to install the system. Insert the USB flash drive into the netbook and turn it on. Press DEL (or F2) to enter the motherboard CMOS settings when booting. Set the first boot device to be USB or removable device. It can be started successfully.
Step 5, boot with U disk. Enter WINPE, the new book should be partitioned first, then double-click the “automatic installation system” in the lower left corner of the desktop. “Step 6”, press any key to start copying the system. After copying, the system will restart automatically.
Note: U disk must be dialed when the system restarts.
After rebooting, the system will automatically deploy and install, including common software and hardware drivers.