One-click GHOST hard disk version Installation and use [Photos]

Graphical introduction describes how to install a key GHOST and common settings.
First, the installation: 1, confirm that your first hard drive is an IDE or SATA hard drive.
Note: If it is a SATA serial hard disk, you generally do not need to set the BIOS. If you can't run GHOST, please set the BIOS to: Compatible (compatible mode) and IDE (ATA mode), as shown below: Note: The above picture is only the most Common CMOS settings are an example. If there are differences, please refer to the motherboard's own manual. 2, download -> Unzip -> Double click " One button GHOST hard disk version. exe " 3, all the way "Next" & rdquo; until the last click & ldquo; Complete & rdquo;.