How to clean the print head under EPSON under WinXP?

When the printer has not been used for a long time, the ink in the nozzle section is easily dried, which will result in no printing and will not print well. At this time, we need to clean the printer nozzle. So how do you clean the printer nozzle? Below, take the Epson printer as an example, Xiaobian to teach you how to clean the epson print head under the WinXP system.

Method /Steps

1. Open the printer and start —— set —— printer and fax machine to find the printer you are using.

2. opening point after the printer to be cleaned, you can see the interface shown below, click the button shown in red frame. After

3. Click the pop-up drop-down menu, select Printing Preferences button in the drop-down menu. After

4. Click Printing Preferences, the following interface will pop up, click on the Advanced button back.

5. This interface will pop up as shown below, shown in half moon click position, the print nozzle detection pattern for detecting nozzle plug case, and as the washing nozzle Compared.

6. After the pop-up interface shown below, click on the button to start printing, print a nozzle test pattern, ready to put a piece of A4 paper in the printer.

7. like print out the pattern detection, and then click the control pattern clean the print head as needed.

8. FIG would then pop up interface, click to start cleaning the print head cleaning, the above steps may be repeated to test the effect of the cleaning after the cleaning is completed.

These are the small series to teach epson print head cleaning method in everyone's WinXP system, should be noted that, if the cleaning effect after printing many times or bad, to be still some time cleaning, general Continuous cleaning should not exceed three times. Please ensure that the ink level is sufficient during the cleaning process.