WinXP system installation printer driver prompts can not find the specified module how to solve?

Recently, users of WinXP system reported that during the process of installing the printer driver, they encountered the problem that the specified module could not be found, and the printer driver could not be installed properly. How to solve this? Let's take a look at it below.

Method /

If the printer driver has been installed, uninstall the failure of a friend, and reboot the system. Be sure to unplug the printer USB cable, and then plug in the USB cable when prompted to connect to the printer! Confirm that the Print Spooler service is turned on.

The method is as follows:

1. From the Start menu, go to - Control Panel - Administrative Tools - Services, find "Print Spooler" in the service, check whether its status is "ld"; Started & rdquo; status.

2. If it is not already started, right click on this item, select Properties, change the startup type to “Auto”, and click the Start button below the service status to start it.

3. Download and install Microsoft .NET Framework 3.5 (If you have previously installed please re-download and install it again).

4. Please restart your computer after installation or repair.

5. In the case where the printer is not connected to the USB cable, the power switch of the printer, let the first ready to start, start using this time, the next step to install the driver.

6. Run the official driver software, go to the second step, and when you click the “Continue” button, you can connect the printer USB cable. Note: Do not click the “Continue” button in this step. After

7. wait for the end of the printer startup, the printer connected to prompt the driver installation process, the printer is connected to a computer USB cable.

8. After the data cable is connected, the system will automatically recognize the printer and pop up the “Found New Hardware Wizard” dialog box. Do not operate this dialog box and drag it to the side for use.

9. Click the driver of the second step & ldquo; continue & rdquo; button.

10. At this time, the installer starts a USB connection, wait 3 to 5 minutes.

11. If, after the previous step to wait for the installation program has been stuck in the USB connection state, had reserved & ldquo; Found New Hardware Wizard & rdquo; dialog this time will be able to play.

12. Select to install from the list or specified location, then click Next to install it step by step.

13. There should be no problem with this step. It is OK to install the universal serial bus controller printer driver in turn. After adding new hardware, the installer will automatically perform subsequent installation.

These are under WinXP system prompts to install the printer driver can not find the solution to a specific module, after the above steps, the printer driver can be installed properly.