WinXP desktop bottom right corner prompts the network computer is not plugged in the reason and solution

Under the WinXP system, the game was played well, and suddenly the network was broken. A small window reminder appeared in the lower right corner of the desktop. The network cable was not plugged in. It was good or bad, and it was connected after a while. Got up, then disconnected, what is going on? The following small series will introduce you to the various reasons and solutions for the computer network cable not plugged in.

to be understood literally problems, mostly due to a physical network connection problems.

The network cable is not plugged in. Reason 1: The problem with the crystal head

If there is a problem with the crystal head, it may cause poor contact with the crystal head of the motherboard, and looseness.

You can first put the crystal head down, and then put it on. Note that you can hear a bang when you go up, indicating that you are safe. If the stability is still stable, the problem remains. Then, it is estimated that there is a problem with the line inside the crystal head. At this time, you have to recreate a new crystal head.

Of course, the problem may not be completely out of the crystal head-to-board this place, there may appear the access switch or access router that place, you have to use the same approach to the investigation.

The network cable is not plugged in. Reason 2: NIC driver

Don't think that there is a problem with the hardware, and the software driver will also have problems.

You can check if it is a driver problem by the following method.

Right-click on my computer and find “Manage”, a dialog box pops up.

In the dialog box, find “Device Manager”, then look at the list to the right, select “network adapter" to see if the icon is a yellow question mark.

If so, the driver has not been installed correctly, this time, you have to re-install the NIC driver, solve the problem.

The network cable is not plugged in. Cause 3: The router has a problem

There is a problem with the router. If it is a soft setting, then please check if the ip is set up in the router. After setting, restart the router.

Also, there is a small hole in the router. If you use wire or fine objects, insert it and wipe it continuously. The route will be reset and started, or it can solve the problem.

Of course, if the route itself is a hardware problem, you have to replace the route, because according to some users reflect the router after being struck by lightning, the local connection will appear & ldquo; network cable is not plugged in & rdquo; the Prompt.

The network cable is not plugged in. Reason 4: Problems with the wireless network

If your network uses a wireless network, then the problem may be on the router.

The reason may be whether the route itself is faulty, and whether there is any signal interference nearby.

The network cable is not plugged in. Reason 5: Don't forget the ARP virus

If you encounter ARP virus in your computer, then this will happen.

You can use anti-virus software to kill the native virus and try to see if it can eliminate the problem.

Or, open the 360ARP firewall and let it provide firewall functionality for your network to protect your network.

The network cable is not plugged in. Cause 6: IP settings or acquisition

The local machine has set the IP address. However, the local connection cannot use the IP address and will be in the state of obtaining the network address for a long time. It is possible that the tips of this article will appear.

In this regard, you must first ensure that the IP settings are correct. In addition, you can disable the local connection and then enable it, which may solve such problems.

The above is the WinXP network computer is not plugged in the solution introduced, not only WinXP system, Win7, Win8, Win10 and other systems can also refer to this tutorial for processing.