How does the WinXP system use the Tracert command? Method using the Tracert command

What is Tracert? I believe everyone should understand it! Tracert, also known as the Windows Route Tracking utility, can be used to determine the path selected by an IP packet access target at the Command Prompt (CMD) using the Tracert command. So how do you use the Tracert command? Let me talk about how to use the Tracert command in the WinXP system and use the Tracert command.

The method/step is as follows:

In the first step, click on the bottom left corner to start.

Step 2, continue to click to run.

The third step, pop-up dialog box.

The fourth step is to enter the command cmd.

The fifth step is to pop up the DOS window.

Step 6. Enter the command Tracert+ domain name as follows.

In the seventh step, the results are as follows.

This is how the WinXP system uses the Tracert command and uses the Tracert command. If you don't know how to use the Tracert command, you can try the above method! The operation is very simple, just follow the above steps to operate.