Notebook xp system to close the redundant interface device optimization performance skills

        WinXP system has many advantages, even if it is stopped by Microsoft, there are still many users using it. Many low-profile computers use the notebook xp system as the preferred installation system, but many users are still not satisfied, and they want to It is configured for optimal performance, with the redundant interface device turned off as a key target.
1, WinXP has a lot of interfaces, compatible with a variety of external interfaces, comes with USB1.1, IEEE1394, PCMCIA and other standard interface drivers is a major advantage. However, there are also many interfaces that are useless. For example, the Ethernet interface is used the most, and the infrared interface is rarely tested. As for the PCMCIA interface and the 1394 interface, it is never used.
2, what we call "interface", its essence is also a device. In order for these devices to work in the operating system, you first need to load the drivers, take up system resources, and secondly consume power. But if you don't need it, isn't it costless? For a PC, it takes a little bit of power to make a few interfaces, but for a notebook, it saves you money.
3, to close the equipment that will not be used for a while, the operation is the most convenient in the device manager, here we can "deactivate" the parallel port, serial port, floppy disk interface and 1394, infrared Interface and more. Just a little bit, we can shield the sound card when we don't listen to the song - this is not too much, the notebook is configured with AC`97 "soft" sound card that requires CPU service, and its resource occupancy rate is not small when it is sounded. .
4, to achieve the closure of some of the devices mentioned above, in the BiOS to make adjustments more thoroughly; but through the device manager to operate, one is simple and convenient to close, both need to be re-enabled when more Convenient, even restarting WinXP is free.
5, close some unnecessary system services is also a common method of pressing the last point of system performance, here some services are directly linked to the interface device, such as the Infrared Monitor and Smart Card services used to display the infrared connection status . The former is used to display the status of the infrared device connection, and the latter is used to manage the smart card, so that some services actually do not have much practical effect. We can save the system resources by setting its startup property to "manual".
6, in addition to Messenger, RPC, Remote Registry such as not much use, but the most vulnerable service, but also set the "manual" mode early.